Port Show Commands
Page 312 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
*A:SAST>show>system#
============================================================
PoE Information
============================================================
PSE Maximum Power Budget : 60 watts
PSE Power Consumed : 0 watts
PSE Power Available : 60 watts
============================================================
PoE Port Information
============================================================
Port-Id PoE Admin/ PoE Oper/ Class
State State
------------------------------------------------------------
1/1/19 Enabled Off None (0 W)
1/1/20 Enabled Off None (0 W)
1/1/21 Enabled Off None (0 W)
1/1/22 Enabled Off None (0 W)
============================================================
A:7210SAST>show>system#
internal-loopback-ports
Syntax internal-loopback-ports [detail]
Context show>system
Description This command displays information about internal loopback ports.
Parameters Detail — keyword - includes application information
Command to display the list of loopback ports assigned to different OAM tools and also the list of
virtual internal port(s) available and its current association.
Sample Output for 7210 SAS-M
*A:7210SAS>config>port# show system internal-loopback-ports detail
===============================================================================
Internal Loopback Port Status
===============================================================================
Port Loopback Application Service
Id Type Enabled
-------------------------------------------------------------------------------
1/1/12 Physical Mac-Swap Yes
1/1/25 Virtual Mac-Swap No
========================================
Mac-swap Application Status
========================================
Enabled : Yes
Test Service Id : 1
To Next Page
Loading...
