Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 317
LACP
Enabled — LACP is enabled.
Down — LACP is disabled.
LACP Transmit
Intvl
LACP timeout signalled to peer.
Selection Crite-
ria
Configured subgroup selection criteria.
Number of sub-
groups
Total subgroups in LAG.
System ID
System ID used by actor in LACP messages.
Admin Key
Configured LAG key.
Oper Key
Key used by actor in LACP messages.
System Priority
System priority used by actor in LACP messages.
Prtr System ID
System ID used by partner in LACP messages.
Prtr Oper Key
Key used by partner in LACP messages.
Prtr System Pri-
ority
System priority used by partner in LACP messages.
Mode
LAG in access or network mode.
Opr
Up — The LAG is operationally up.
Down — The LAG is operationally down.
Port Threshold
Configured port threshold.
Thres. Exceeded
Cnt
The number of times that the drop count was reached.
Threshold Action
Action to take when the number of available links is equal or below the
port threshold.
Encap Type
The encapsulation method used to distinguish customer traffic on a
LAG.
Lag-IFIndex
A box-wide unique number assigned to this interface.
Port ID
The specific slot/MDA/port ID.
(LACP) Mode
LACP active or passive mode.
LACP xmit
standby
LACP transmits on standby links enabled / disabled.
Slave-to-partner
Configured enabled/disabled.
Port-id
Displays the member port ID.
Label Description (Continued)
To Next Page
Loading...
