Alcatel-Lucent 7210 SAS M - Page 51

LAG
Page 46 7210 SAS M, T, X, R6, R12, Mxp Interface Configu-
ration Guide
Epipe service:
SAP to SDP
IP traffic: Source and Destination IP, Source
and Destination L4 ports, Ingress Port-Id.
PBB traffic: BDA, BSA, ISID, Ingress Port-
Id.
MPLS traffic: MPLS label stack (Two labels
deep), Ingress Port-Id.
Non-IP traffic: Source and Destination MAC,
EtherType, VLAN, Ingress Port-Id.
VPLS service:
SDP to SAP
Non-IP traffic (Learnt): Source and
Destination MAC (Outer MACs inside the
payload, just after the MPLS header),
EtherType.
All other traffic (Learnt): Source and
Destination MAC (Outer MACs inside the
payload, just after the MPLS header).
All traffic (Unlearnt): Source and Destination
MAC (Outer MACs inside the payload, just
after the MPLS header), Ingress Port-Id.
Epipe service:
SDP to SAP
Non-IP traffic: Source and Destination MAC
(Outer MACs inside the payload, just after the
MPLS header), EtherType
All other traffic: Source and Destination MAC
(Outer MACs inside the payload, just after the
MPLS header)
LAG Hashing Fields used for 7210 SAS-M (Network
mode)
Table 7: LAG Hashing mechanism for services configured in Network Mode on 7210 SAS-
M devices
Services and Traffic Direction
(For example: SAP to SDP)
Packet fields used for Hashing for different
traffic types