Alcatel-Lucent 7210 SAS M - Page 52

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 47
VPLS service:
SDP to SDP
Non-IP Traffic (Learnt): Source and
Destination MAC (Outer MACs inside the
payload, just after the MPLS header), Ingress
Port-Id, EtherType.
All other traffic: Source and Destination MAC
(Outer MACs inside the payload, just after the
MPLS header), Ingress Port-Id.
MPLS – LSR All traffic: MPLS label stack (Two labels
deep), Ingress Port-Id.
PBB VPLS service:
PBB BCB Traffic (that is, B-SAP
to B-SAP)
IP traffic (learnt): Source and Destination IP,
Source and Destination L4 ports
IP traffic (unlearnt): Source and Destination
IP, Source and Destination L4 ports, Ingress
Port-Id.
L2/non-IP traffic (learnt): BDA, BSA
L2/non-IP traffic (unlearnt): BDA, BSA,
ISID, Ingress Port-Id
LAG Hashing Fields used for 7210 SAS-M (Network
mode)
Table 7: LAG Hashing mechanism for services configured in Network Mode on 7210 SAS-
M devices
Services and Traffic Direction
(For example: SAP to SDP)
Packet fields used for Hashing for different
traffic types