7705 SAR Interfaces
7705 SAR OS Interface Configuration Guide Page 109
short-sequence
Syntax [no] short-sequence
Context config>port>multilink-bundle
Description This command specifies that the MLPPP bundle should use short (12 bit) sequence numbers instead
of the default 24-bit sequence number. This command is only valid for MLPPP bundles.
The no form of this command disables the short-sequence feature.
Default no short-sequence
yellow-differential-delay
Syntax yellow-differential-delay yellow-diff-delay
no yellow-differential-delay
Context config>port>multilink-bundle
Description This command sets the yellow warning threshold for the differential delay for members within a
multilink bundle. If circuit’s delay exceeds the yellow-differential delay value, a log message and
SNMP trap is sent. This command is only valid for MLPPP bundles.
The no form of this command removes the yellow-differential-delay.
Default None
Parameters yellow-diff-delay — the maximum yellow differential delay threshold value, in milliseconds
Values 1 to 25 ms
ima
Syntax ima
Context config>port>multilink-bundle
Description This command enables the context to configure parameters for an IMA group. An IMA group is a
collection of physical links bundled together and assigned to an ATM port. IMA enables a high-speed
channel that is composed of ATM cells to be transported as a number of lower-speed circuits. They
are then reassembled as the original high-speed ATM channel.
This command is only valid for IMA bundles.
To Next Page
Loading...
