Card, Adapter Card, and Port Command Reference
Page 110 7705 SAR OS Interface Configuration Guide
link-delay
Syntax link-delay {activate | deactivate} milliseconds
no link-delay {activate | deactivate}
Context config>port>multilink-bundle>ima
Description This command specifies the time delay between detection of a link activation/deactivation condition
and acting upon it (going in/out of the Rx failure state on a link).
Parameters activate milliseconds — the time, in milliseconds, used to clear an existing LIF, LODS, or FRI-IMA
alarm. The time specified determines how long is needed for member links to stabilize before
being activated.
Values 1 to 30000 ms
Default 1000
deactivate milliseconds — the time, in milliseconds, used to raise an LIF, LODS, or FRI-IMA alarm.
The time specified determines how long before a member link is declared in error and is
deactivated.
Values 1 to 30000 ms
Default 2000
test-pattern-procedure
Syntax test-pattern-procedure
Context config>port>ml-bundle>ima
Description This command enables the context to configure IMA test pattern procedures. Note that this command
and sub-commands are not saved in the router configuration between reboots.
test-link
Syntax test-link port-id
no test-link
Context config>port>ml-bundle>ima>test-pattern-procedure
Description This command specifies IMA members on which an IMA test pattern procedure is to be performed.
The no form of this command deletes the link from the test-pattern procedure. The test-pattern
procedure must be shut down first.
Default no test-link
Parameters port-id — the port ID to be used to verify link connectivity within an IMA group
To Next Page
Loading...
