7705 SAR Interfaces
7705 SAR OS Interface Configuration Guide Page 125
ppp
Syntax [no] ppp
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command enables access to the context to configure the LCP operational parameters for a DS1
or E1 channel or a DS0 channel.
The no form of the command removes the LCP operational parameters.
Default no ppp
keepalive
Syntax keepalive time-interval [dropcount drop-count]
no keepalive
Context config>port>tdm>ds1>channel-group>ppp
config>port>tdm>e1>channel-group>ppp
Description This command sets the keepalive interval.
The no form of this command returns the interval to the default value.
Default 10
Parameters time-interval — the time in seconds between keepalive messages, expressed as a decimal integer
Values 1 to 60 seconds
drop-count — the number of consecutive keepalive failed request attempts or remote replies that can
be missed after which the port is operationally downed
Values 1 to 255
scramble
Syntax scramble
no scramble
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command enables payload scrambling on channel groups. The command is applicable only if the
encapsulation type is atm.
To Next Page
Loading...
