Alcatel-Lucent 7705 - Fan Module Connectors and LEDs

Card, Adapter Card, and Port Command Reference
Page 130 7705 SAR OS Interface Configuration Guide
Sample Output
The following examples display the card state for a 7705 SAR-8 and a 7705 SAR-F.
For the 7705 SAR-8:
ALU-1>config# show card state
Card State
===============================================================================
Slot/ Provisioned Equipped Admin Operational Num Num Comments
Id Type Type State State Ports MDA
-------------------------------------------------------------------------------
1 iom-1g iom-1g up up 6
1/1 a4-oc3 up provisioned 4
1/2 a4-oc3 up provisioned 4
1/3 a16-chds1 a16-chds1 up failed 16
1/4 a16-chds1 a16-chds1 up failed 16
1/5 a8-eth a8-eth up up 8
1/6 a8-eth a8-eth up up 8
A csm-1g csm-1g up up Active
B csm-1g up down Standby
===============================================================================
For the 7705 SAR-F:
ALU-2# show card
===============================================================================
Card State
===============================================================================
Slot/ Provisioned Equipped Admin Operational Num Num Comments
Id Type Type State State Ports MDA
-------------------------------------------------------------------------------
1 iom-1g iom-1g up up 2
1/1 a16-chds1 a16-chds1 up provisioned 16
1/2 a8-ethv2 a8-ethv2 up provisioned 8
A csm-1g csm-1g up up Active
================================================================================
ALU-2>#
Num MDA The number of adapter cards installed
Comments Indicates which CSM is the active card and which is in standby mode
(for redundancy)
Table 5: Show Card State Output Fields (Continued)
Label Description
Note: The show card command for the 7705 SAR-F will always appear as shown because
it has a fixed physical configuration.