Card, Adapter Card, and Port Command Reference
Page 158 7705 SAR OS Interface Configuration Guide
Sample Output
*A:ALU-1># show port 1/5/1
===============================================================================
Ethernet Interface
===============================================================================
Description : 10/100 Ethernet TX
Interface : 1/5/1 Oper Speed : N/A
Link-level : Ethernet Config Speed : 100 mbps
Admin State : down Oper Duplex : N/A
Oper State : down Config Duplex : full
Physical Link : No MTU : 1514
IfIndex : 44072960 Hold time up : 0 seconds
Last State Change : 10/30/2008 14:40:56 Hold time down : 0 seconds
Last Cleared Time : N/A
Configured Mode : access Encap Type : null
Dot1Q Ethertype : 0x8100
Ing. Pool % Rate : 100 Egr. Pool % Rate : 100
Net. Egr. Queue Pol: default
Egr. Sched. Pol : n/a
Auto-negotiate : true MDI/MDX : unknown
Egress Rate : Default Ingress Rate : n/a
Configured Address : a4:58:01:05:00:01
Hardware Address : a4:58:01:05:00:01
Cfg Alarm :
Alarm Status :
===============================================================================
Traffic Statistics
===============================================================================
Input Output
-------------------------------------------------------------------------------
Octets 0 0
Packets 0 0
Errors 0 0
===============================================================================
Late Collisions The number of times that a collision is detected later than one slotTime
into the transmission of a packet
Excess Collisns The number of frames for which a transmission fails due to excessive
collisions
Int MAC Tx Errs The number of frames for which a transmission fails due to an internal
MAC sublayer transmit error
Int MAC Rx Errs The number of frames for which a reception fails due to an internal
MAC sublayer receive error
Table 15: Show Specific Port Output Fields (Ethernet Port) (Continued)
Label Description
To Next Page
Loading...
