Interfaces
Page 446 7750 SR Interface Configuration Guide
endpoint-discriminator
Syntax endpoint-discriminator class {ip-address | global-mac-address | null} [discriminator-id
discriminator-id]
no endpoint-discriminator
Context config>port>ml-bundle>mlppp
Description This command configures the endpoint-discriminator class and ID. The port must be shutdown to modify
command parameters.
The no form of the command removes the parameters from the configuration.
Parameters class — Specifies the Link Control Protocol endpoint descriminator class field type.
Values ip-address, global-mac-address, null
Default Bundle type Default
Physical MLPPP bundle ieee802dot1GlobalMacAddress
MLPPP bundle protection group IP address
discriminator-id discriminator-id — Specifies the endpoint discriminator identifier value within the speci-
fied endpoint-discriminator class. The values below are only for the ip-address class.
Values Any valid IP address.
qos-profile
Syntax qos-profile profile-id
no qos-profile
Context config>port>ml-bundle>mlppp>ingress
Description This command specifies the ingress QoS profile to be used for the incoming traffic over this MLPPP bundle.
Parameters profile-id — Specifies the ingress QoS profile to be used for the incoming traffic over this MLPPP bundle.
The value can only be modified if the bundle is shutdown.
Values 1 — 128
magic-number
Syntax [no] magic-number
Context config>port>ml-bundle>mlppp
Description This command allows loopback detection to be enabled and disabled for MLPPP bundles. It is disabled by
default. When the magic number option is disabled, the magic number option will not be requested when a
member is trying to bring up the LCP layer on a member link; if the remote peer requests this option, it will
be rejected. When transmitting echo-requests a magic number of 0 is used. When responding to echo-
requests a magic number of 0 is sent.
To Next Page
Loading...
