3 Maintain the ATCA Subrack
3.5.2.3 Update the NE1OE Firmware for the New JBXTP or JBXMUX Boards
Firmware update must be performed on the standby board. Ensure the
concerned board is not the active one.
To update the NE1OE for the new JBXTP or JBXMUX boards:
1. Connect on the active station:
telnet 172.17.33.1
2. Check NE1OE package version
The following command gives the <nE1OE package> file name:
cd /tftpboot
ls |grep ’nE1OE_pkg’
nE1OE_pkg_1_6_00-r01.tar.gz
nE1OE_pkg_1_6_00-r01.tar.gz (Example)
The following table gives the FRU ID module allocation.
FRU Name FRU ID
JBXTP1 3/1.x.1
JBXTP2 3/1.x.2
JBXMUX1 6/1.y.10
JBXMUX2 6/1.y.12
Where:
x is 3 for ATCA Shelf 3
x is 4 for ATCA Shelf 4
y is 1 for LIU Shelf 1
y is 2 for LIU Shelf 2.
3. Launch the update script for the respective FRU:
cd /usr/local/fw_upgrade/script
./transFw -single <FRU ID> -ne1oe <nE1OE package>
....................................................................
FW Upgrade Warning started on FRU <FRU ID> <Ref nr.>
Proceed to FW Upgrade of the selected FRUs ? [n]:
y
--> NE1oE FW Upgrade on FRU <FRU ID>(<nE1OE
package>). .
NE1oE FW Upgrade request succesfully sent (Ref.:
<Ref nr.>, FRU <FRU ID>).
NE1oE FW Upgrade ack received (Ref.: <Ref nr.>).
NE1oE FW Upgrade ongoing on FRU <FRU ID>. Please
wait...
Operation takes around 20 minutes.
Wait for the update message:
NE1oE FW Upgrade report received for FRU <FRU ID>.
3BK 21281 AAAA PCZZA Ed.13 35 / 90
To Next Page
Loading...
