3 Maintain the ATCA Subrack
NE1oE FW Upgrade succesfully performed on <FRU ID>.
FW Upgrade Warning stopped on FRU <FRU ID> (Ref.:
<Ref nr.>).
4. Reset the replaced board to take into account the new firmware version:
Click on Start -> Programs -> WinBSC -> 9130BSC –> B10 –> Windows
9130 BSC BSC Terminal B10 to open the BSC terminal from the Local PC
and introduce the Virtual IP address of the BSC.
The Virtual IP address is 172.17.33.1
From the BSC Terminal menu bar, follow the menu path: Utilities->Switch
User Mode or press [ F6 ] to switch to Master User Mode.
From the BSC Terminal menu bar, follow the menu path:
Commands->Equipment Handling->SBL Reset.
The "SBL Reset" window opens.
In the ’Object Class’ field, select SBL
In the ’Unit Type’ field, select the unit type, BSC
In the ’SBL Type’ field, select:
’TP-HW’ if the replaced FRU is JBXTP
’ECU’ if the replaced FRU is JBXMUX.
In the ’Unit Number’ field, enter the unit number ’1’
In the ’Nbr’ field, enter the SBL number:
’1’ if the replaced FRU is JBXTP1 or JBXMUX1
’2’ if the replaced FRU is JBXTP2 or JBXMUX2.
In the ’SubNbr’ field, enter the SBL sub-number ’255’
Click on [ OK ] to reset the SBL.
Wait until the status in ’Job Result’ field is SUCCESSFUL
5. At BSC Terminal check that the alarm “FIRMWARE-NOT-UP-TO-DATE” was
cleared or the alarm end message is present.
6. Close "Windows BSC Terminal" window.
36 / 90
3BK 21281 AAAA PCZZA Ed.13
To Next Page
Loading...
