3 Maintain the ATCA Subrack
12. Copy the shelf information to the replaced JAXPC
If the replaced board is JAXPC1 enter:
ipmitest /READFRU 0 0 0x16 1 shelf.txt
The following message is displayed:
V1.60 - Copyright 2001 Force Computers
FRU size is 2048
ipmitest /WRITEFRU 0 0 0x14 1 shelf.txt
The following message is displayed:
V1.60 - Copyright 2001 Force Computers
FRU size is 2048
Command 12H return with Status C9H=Parameter out
of range.
If the replaced board is JAXPC2
ipmitest /READFRU 0 0 0x14 1 shelf.txt
The following message is displayed:
V1.60 - Copyright 2001 Force Computers
FRU size is 2048
ipmitest /WRITEFRU 0 0 0x16 1 shelf.txt
The following message is displayed:
V1.60 - Copyright 2001 Force Computers
FRU size is 2048
Command 12H return with Status C9H=Parameter out
of range
13. From the active JAXSMM open a telnet session on the standby JAXSMM
# telnet 192.168.101.z
where:
z is 8 if JAXSMM2 is active
z is 9 if JAXSMM1 is active
14. On the standby JAXSMM check that the OK green LED is ON.
15. Activate the standby JAXSMM
# sv_activate
The red OOS LED on the replaced JAXPC is switched OFF.
16. Close the telnet session on the JAXSMM
17. Activate the current standby JAXSMM to return to the initial state
# sv_activate
18. Close the telnet session on the JAXSMM
19. Close the telnet session on the JBXOMCP.
50 / 90
3BK 21281 AAAA PCZZA Ed.13
To Next Page
Loading...
