Alcatel-Lucent OmniTouch 8082 My IC - Install the Alcatel-Lucent My IC Phone Bluetooth Wireless Handset

44
After pairing the Bluetooth® accessory, you must define the accessory type in the audio settings.
 Select the application.
Settings
 Device Audio Accessory type BT Ok
Select the type of accessory that you have just added:
 Bluetooth® accessory
o Headset
o Handsfree
o Loudspeaker
 Ok
All devices other than the Alcatel-Lucent My IC Phone Bluetooth® Wireless Handset will be treated as
headset device.
8.15 Install the Alcatel-Lucent My IC Phone Bluetooth® Wireless handset
 Select the application.
Settings
 Device Bluetooth®
 Add
 Scan
The set scans for available Bluetooth® devices...
 Your Bluetooth® device needs to be prepared for pairing. Take the handset off the hook
and switch it off, then press and hold both handset buttons at the same time. You will hear a
3-note tone and the LED will flash green and orange.
 Searching for Bluetooth® equipment. Wait for the detected equipment type and address to
be displayed.
 Select the relevant equipment.
 Add
 Enter the device PIN code ( The default PIN code is 0000).
 Ok
The 3-note tone indicates that the handset has been installed correctly (the LED flashes
green or orange depending on the battery charge level).