- 3-
1.1 Safety Description
Phoenix series swing-arm robots have been designed and manufactured by
ALFA AUTO in consideration for the use with any make of horizontal plastics
injection moulding machines, therefore the company shall be free from any
obligation and responsibility for any accident or injury incurred while using
this robot with other type of machine or applications. We strongly suggest you
to read the following safety standards thoroughly and observe them before
putting the robot into operation:
(1) This robot has been designed and manufactured for the operating of 5,000,000 cycles (Say,
10 years x 280 days x 8 hours x 60 minutes x 4cycles = 5,000,000 cycle) under normal
operating conditions.
(2) This robot has been designed and manufactured in conformity with EN292-1 and EN292-2
standards.
(3) This robot requires necessary adjustment and maintenance as stipulated in this manual;
therefore we strongly suggest you to read and observe the notices carefully before any
adjustment and maintenance are carried out.
(4) The necessary warning labels are stuck on this robot. Please pay attention to read the
warning labels before and during operation.
(5) Safety regulations shall be highly complied while handling and transportation of the robot.
(6) A well-informed and fully trained operator only can operate this robot.
(7) All operation, adjustment and control of this robot must be carried out in full accordance
with description of this manual.
(8) Risk working areas are noted in this manual. System integrator must install appropriate
safeguarding surrounding the risk working areas.
(9) Do not operate this robot in case there is a person working or standing in the risk areas.
(10) The hand-held pendant must be hung and operated outside the risk areas during
operation.
(11) During maintenance or a mold change, electrical power must be turned off and the
pneumatic source is disconnected.
(12) This robot is equipped with trouble detective function. The user may rectify the problems
according to the trouble-shooting guide themselves or contact your local supplier for
service. The trained operator is allowed to handle only.
(13) In addition to the replacement of proximity switches, vacuum and grip sensors, please
contact your local supplier for other repairs and maintenance.
1.2 Warranty and Non-warranty
1.2.1 Warranty Period
To Next Page
Loading...
Need help?
General
