Allied Telesis AT-8000S - Chapter 8. Ethernet Configuration Commands; interface ethernet; interface range ethernet

Page 99
Not approved by Document Control. For review only.
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the DHCP snooping configuration.
show ip dhcp snooping binding
The show ip dhcp snooping binding User EXEC mode command displays the DHCP snooping binding
database and configuration information for all interfaces on a switch.
Syntax
show ip dhcp snooping binding [mac-address mac-address] [ip-address ip-address] [vlan vlan] [ethernet
interface | port-channel port-channel-number]
Parameters
•
mac-address — Specify a MAC address
• ip-address — Specify an IP address.
• vlan-id — Specify a VLAN number.
• interface — Specify Ethernet port.
• port-channel-number — Specify Port-channel number
Default Configuration
This command has no default configuration.
Command Mode
EXEC
User Guidelines
There are no user guidelines for this command.
Example
console# show ip dhcp snooping binding
Total number of binding: 2
MAC Adreess IP Address Lease (sec) Type VLAN Interface
------------------ --------------- ------------ ---------- ---- ----------
00:60:70:4c:73:ff 10.1.8.1 4294967295 snooping 3 1/e21
00:60:70:4c:7f:c1 10.1.8.2 4294967295 snooping 3 1/e22
console#