Allied Telesis AT-8000S - Show Lacp Port-Channel

Page 173
Not approved by Document Control. For review only.
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
show lacp port-channel
The show lacp port-channel Privileged EXEC mode command displays LACP information for a port-channel.
Syntax
show lacp port-channel [port_channel_number]
Parameters
•
port_channel_number — Valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays LACP information about port-channel 1.
console# show lacp port-channel 1
Port-Channel 1: Port Type 1000 Ethernet
Actor
System Priority: 1
MAC Address: 00:02:85:0E:1C:00
Admin Key: 29
Oper Key: 29
Partner
System Priority: 0
MAC Address: 00:00:00:00:00:00
Oper Key: 14