Allied Telesis AT-8000S - Clear Logging

Page 303
Not approved by Document Control. For review only.
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Syntax
logging buffered size number
no logging buffered size
Parameters
•
number — Specifies the maximum number of messages stored in the history table. (Range: 20 - 400)
Default Configuration
The default number of messages is 200.
Command Mode
Global Configuration mode
User Guidelines
This command takes effect only after Reset.
Example
The following example changes the number of syslog messages stored in the internal buffer to 300.
clear logging
The clear logging Privileged EXEC mode command clears messages from the internal logging buffer.
Syntax
clear logging
Parameters
This command has no arguments or keywords.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example clears messages from the internal logging buffer.
console(config)# logging buffered size 300
console# clear logging
Clear logging buffer [y/n]