Allied Telesis AT-8000S - Tacacs-Server Source-Ip; Show Tacacs

Page 313
Not approved by Document Control. For review only.
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Default Configuration
5 seconds
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the timeout value to 30.
tacacs-server source-ip
The tacacs-server source-ip Global Configuration mode command configures the source IP address to be used
for communication with TACACS+ servers. Use the no form of this command to return to the default configuration.
Syntax
tacacs-server source-ip source
no tacacs-server source-ip source
Parameters
•
source — Specifies the source IP address.
Default Configuration
The source IP address is the address of the outgoing IP interface.
Command Mode
Global Configuration mode
User Guidelines
N/A
Example
The following example specifies the source IP address.
show tacacs
The show tacacs Privileged EXEC mode command displays configuration and statistical information about a
TACACS+ server.
console(config)# tacacs-server timeout 30
console(config)#
tacacs-server source-ip 172.16.8.1