Page 143
Not approved by Document Control. For review only.
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Default Configuration
No host is defined.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example defines a static host name-to-address mapping in the host cache.
clear host
The clear host Privileged EXEC mode command deletes entries from the host name-to-address cache.
Syntax
clear host {name | *}
Parameters
•
name — Specifies the host entry to be removed. (Range: 1-158 characters)
• * — Removes all entries.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example deletes all entries from the host name-to-address cache.
clear host dhcp
The clear host dhcp Privileged EXEC mode command deletes entries from the host name-to-address mapping
received from Dynamic Host Configuration Protocol (DHCP).
Syntax
clear host dhcp {name | *}
console(config)#
ip host
accounting.website.com 176.10.23.1
console#
clear host
*
To Next Page
Loading...
Need help?
General
