Allied Telesis AT-8000S - lacp port-priority

LACP Commands
Page 168
Chapter 16.LACP Commands
lacp system-priority
The lacp system-priority Global Configuration mode command configures the system priority. Use the no form of
this command to return to the default configuration.
Syntax
lacp system-priority value
no lacp system-priority
Parameters
•
value — Specifies system priority value. (Range: 1 - 65535)
Default Configuration
The default system priority is 1.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the system priority to 120.
console(config)# lacp system-priority 120