Allied Telesis AT-8000S - Show Line

Page 161
Not approved by Document Control. For review only.
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Example
The following example configures the command history buffer size to 20 commands for the current terminal
session.
show line
The show line User EXEC mode command displays line parameters.
Syntax
show line [console | telnet | ssh]
Parameters
•
console — Console terminal line.
• telnet — Virtual terminal for remote console access (Telnet).
• ssh — Virtual terminal for secured remote console access (SSH).
Default Configuration
If the line is not specified, the default value is console.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the line configuration.
console# terminal history size 20
console>
show line
Console configuration:
Interactive timeout: Disabled
History: 10
Baudrate: 9600
Databits: 8
Parity: none
Stopbits: 1
Telnet configuration:
Interactive timeout: 10 minutes 10 seconds
History: 10