Allied Telesis AT-8000S - Show Snmp Groups

Page 259
Not approved by Document Control. For review only.
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the configuration of views.
show snmp groups
The show snmp groups Privileged EXEC mode command displays the configuration of groups.
Syntax
show snmp groups [groupname]
Parameters
•
groupname — Specifies the name of the group. (Range: 1-30)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays the configuration of views.
console# show snmp views
Name OID Tree Type
----------- ----------------------- ---------
user-view 1.3.6.1.2.1.1 Included
user-view 1.3.6.1.2.1.1.7 Excluded
user-view 1.3.6.1.2.1.2.2.1.*.1 Included
console#
show snmp groups
Name Security Views
Model Level Read Write Notify
-------------- ----- ----- ------- ------- -------