Page 229
Not approved by Document Control. For review only.
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Default Configuration
The timeout value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the timeout interval to 5 seconds.
radius-server deadtime
The radius-server deadtime Global Configuration mode command improves RADIUS response time when
servers are unavailable. The command is used to cause the unavailable servers to be skipped. Use the no form of
this command to return to the default configuration.
Syntax
radius-server deadtime deadtime
no radius-server deadtime
Parameters
•
deadtime — Length of time in minutes during which a RADIUS server is skipped over by transaction
requests. (Range: 0 - 2000)
Default Configuration
The deadtime setting is 0.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the deadtime to 10 minutes.
show radius-servers
The show radius-servers Privileged EXEC mode command displays the RADIUS server settings.
console(config)# radius-server timeout 5
console(config)# radius-server deadtime 10
To Next Page
Loading...
