Allied Telesis AT-8000S - Snmp-Server Location; Snmp-Server Set

Page 255
Not approved by Document Control. For review only.
Allied Telesis
AT-8000S-S94-3.0 Command Line Interface User’s Guide
Command Mode
Global Configuration mode
User Guidelines
Do not include spaces in the text string or place text that includes spaces inside quotation marks.
Example
The following example configures the system contact point called ATI_Technical_Support.
snmp-server location
The snmp-server location Global Configuration mode command configures the system location string. Use the
no form of this command to remove the location string.
Syntax
snmp-server location text
no snmp-server location
Parameters
•
text — Specifies a string that describes system location information. (Range: 0-160 characters)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
Do not include spaces in the text string or place text that includes spaces inside quotation marks.
Example
The following example defines the device location as New_York.
snmp-server set
The snmp-server set Global Configuration mode command defines the SNMP MIB value.
Syntax
snmp-server set variable-name name1 value1 [ name2 value2 …]
console(config)# snmp-server contact ATI_Technical_Support
console(config)# snmp-server location New_York