Allsteel Optimize - Base or Ceiling Side In-Feed Installation

343-3512A (03/13)
9 of 27
Optimize
Illustration 6. Base or Ceiling Side In-Feed Installation
Improperly installed electrical components can fail resulting in personal injury and/or property damage.
Connection of the in-feed device to the power source should be performed by a licensed electrician in
compliance with all national and local electrical codes.
To prevent personal injury, ensure in-feed power is disconnected before component installation.
WARNING
Illustration 6a: Remove In-Feed Cover
Illustration 6c: Pass In-Feed Connector Through
Baserail cover
Illustration 6e: Connect Infeed Connector Illustration 6f: Reattach In-Feed Cover
Illustration 6d: Reassemble Swivel Joint
Illustration 6b: Disconnect Swivel Joint and Remove
Swivel tabs
In-feed cover - install
after power in-feed
and baserail cover is
in place
Note: In-feed cable can be shortened. Remove and reapply
UL listing/schematic, near end of cable, as needed.
180° swivel joint
Swivel joint - disconnect
and hook into in-feed
connector
Swivel joint
In-feed connector
In-feed
connector
In-feed connector
Baserail cover
Baserail cover
Baserail cover
Baserail cover
Power block
In-feed
connector
In-feed cover -
remove and save
Screw - remove
and save
Screw
Swivel tab - remove
and save
Swivel tab
Route cable to power source (refer to wiring diagram
on page 7 for proper wiring connections).
8 Wire Electrical Installation