343-3512A (03/13)
16 of 27
Optimize
Wood screw
A
B
C
Support
Column
• Install support column so that a center line
through the leveling glides is parallel with
the rear edge of worksurface.
• This applies only to support columns
with two levelers.
• Install support
column so it is
centered in the
radius end of
the peninsula.
Verify the
measurements
are equal from
3 tangents
(marked A, B
and C).
Rear edge
Center line
Illustration 9: Support Column (use with peninsula and D-shaped worksurfaces)
Leveling
glides
Worksurface Supports Installation
To Next Page
Loading...
