malletKAT User Manual (ver.07-17-18)
CHAIN MODE
Chain mode is fully described in the section How To Create a Chain(https://alternatemode.com/online-
docs/malletkat/#how-to-create-a-chain)
Global Auxiliary Shortcut #77
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
CHORD MODE WINDOW
Parameters = 01-20 milliseconds
This is a Sensitivity control function when using the MELODY CHORD MODE(https://alternatemode.com/online-
docs/malletkat/#melodic-chord-mode)
. The parameters in this screen control how close together a pair of notes must be to be considered a chord. The
lower the number, the lower the latency because the malletKAT has to wait until the programmed time has
elapsed to determine if you are playing a single note or chord.
Global Auxiliary Shortcut #16
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
DAMPEN COUNT
Parameters = 0-255
This setting is used to adjust the time between striking a pad and when the pad may be dampened when in
DAMPEN MODE. Making this setting greater makes dampening more dif cult, lowering it makes dampening
easier. If the value is too low, slight bounces of your mallet on the pads may dampen notes when you don’t want
them to.
Global Auxiliary Shortcut #43
malletKAT Express
Auxiliary Editing Screens require pressing the Edit Footswitch and Sustain 1 pedal at the same time (See Section
4.1.1(https://alternatemode.com/online-docs/malletkat/#malletkat-express-accessing-editing-functions)
)
DAMPEN MODE SCAN COUNT
Parameters = 0-16
85 / 109
To Next Page
Loading...
