100
About Moulds
Moulds are microscopic organisms that naturally occur in virtually every environment, indoors
and out. Outdoors, mould growth is important in the decomposition of plants. Indoors, mould
growth is unfavourable. Left unchecked, moulds breakdown natural materials, such as wood
products and fabrics. Knowing the potential risks is important to protect one’s investment.
For mould growth to occur, temperatures, indoors or out, must be between 4 °C and 38 °C (40 °F
and 100 °F) and also have a source of moisture, such as humidity, standing water, damp materials,
etc. Indoors, the most rapid growth occurs with warm and humid conditions.
How can mould growth be inhibited? By controlling relative humidity, the growth of mould and
mildew can be inhibited. In warm climates, use of the air conditioner will reduce the relative
humidity. Vent use is advised during food preparation and bathing, even during colder weather.
Additionally, opening a window during these activities will assist in ventilation. In extremely
humid conditions, the use of a dehumidifier can be helpful.
If using a dehumidifier, please read and follow all manufacturer instructions and
recommendations in the use and cleaning of the dehumidifier.
Frequent use of your trailer or regular cleaning is an important preventive measure. Further, any
spills should be wiped up quickly and dried as soon as possible. Avoid leaving damp items lying
about. On safe surfaces, use mould or mildew killing cleaning products. Check sealants regularly,
and reseal when necessary to avoid water leaks. Proper preventive maintenance to the trailer
and its accessories, as described both in this manual and in accompanying literature, will provide
the best protection for your trailer.
Cleaning
As a general rule of thumb, we recommend the trailer be washed every four weeks and waxed in
the spring and fall. In coastal and industrial areas cleaning and waxing should be done on a more
frequent schedule. When travelling through winter weather, all road treatment chemicals should
be removed immediately.
NOTICE: Abrasive polishes or cleaning solvents such as automatic dishwasher detergents or acid
etch cleaners are too strong and should never be used.
Rinse all grit from surface prior to washing. Do not use wire brushes, steel wool, abrasives
or other similar cleaning tools that will mechanically abrade the coating surface. Always test
a small inconspicuous area first.
Always clean your trailer in the shade or on a cloudy day when the aluminum skin is cool.
Use soft rags and never rub hard on the coating. Oil, grease, dust and dirt may be removed by
washing with a 5% solution in water of commonly used commercial and industrial detergents.
Cleaning should be followed by a thorough clean water rinse. Drying the unit with a chamois or a
soft cloth may prevent spots and streaks.
To Next Page