107
Resuming Use of Aquago Confort Plus Water Heater
1. To resume use of your Aquago water heater, open the heater access door, trigger the
toggle lever open (photo O-6), reinstall the filter cartridge, close the toggle lever and close
access door (photo O-7).
2. Open the A and B bypass valves (photos O-5.2 and O-5.3) to the horizontal position
3. Open return line E valve (photo O-5.4).
4. Put the pump switch to “ON”.
5. Open D valve (photo O-5.1) and let about 2 litres of water run on the ground under the
vehicle to fill the water heater and return line.
6. You can now turn on your water heater and use it.
Simple Procedure to Prevent Freezing when Using ALTO
1. Turn on your Aquago water heater using the internal switch in ECO mode (photo O-7.2).
2. In this mode, your Aquago will keep the water between 4 °C and 60 °C.
3. Note that in this mode there will be some propane and 12 volts consumption.
4. It is a practical solution for one night but not more as the quick and simple winterizing
procedure is recommended for more than 24 hours as it does not use electricity or
propane.
1 2
PHOTO O-7
Toggle lever hatch
To Next Page
Loading...