23
Water Pump
“Pump” switch is located on the level Monitor Panel located by the entrance (photo F-1.3). Once
the switch is turned on, the pump will run until the water pressure reaches about 448 kPa (65 Psi)
At this point an internal pressure switch will shut it off. When a faucet is opened, the water
pressure will drop and the pump will start to run again. The water pump switch should be turned
off when the trailer is left unattended.
Water pressure at some campgrounds may be low. The water pump can be turned on to assist
the city water hookup pressure. Be sure there is some water in the potable water tank. The pump
will only use the water that is needed out of the tank to bring the pressure up to the usual
standard.
Pump Switch
To activate water pump, use “PUMP” switch (photo F-1.3) on Monitor Panel located inside by the
door. Indicator light is on when pump is “ON”.
The water pump will start automatically every time the hot or cold water tap is turned on.
If your water tank runs dry, the pump will keep running. This will cause damage to the pump after
a while.
The “PUMP” switch (photo F-1.3) lets you stop the pump when tank runs dry, or when pump is
not in use.
IMPORTANT: Never operate water pump with an empty tank.
IMPORTANT: Before plugging the water heater, make sure water heater is full.
WARNING:
HYDROGEN GAS CAN BE PRODUCED IN A HOT-WATER SYSTEM SERVED BY THIS
HEATER THAT HAS NOT BEEN USED FOR A LONG PERIOD OF TIME (GENERALLY TWO WEEKS
OR MORE). HYDROGEN GAS IS EXTREMELY FLAMMABLE. TO REDUCE THE RISK OF INJURY
UNDER THESE CONDITIONS, IT IS RECOMMENDED THAT THE HOT WATER FAUCET HE
OPENED FOR SEVERAL MINUTES AT THE KITCHEN SINK BEFORE USING ANY ELECTRICAL
APPLIANCE CONNECTED TO THE HOT WATER SYSTEM. IF HYDROGEN IS PRESENT THERE
WILL PROBABLY BE AN UNUSUAL SOUND SUCH AS AIR ESCAPING THROUGH THE PIPE AS
THE WATER BEGINS TO FLOW. THERE SHOULD BE NO SMOKING OR OPEN FLAME NEAR THE
FAUCET AT THE TIME IT IS OPEN.
To Next Page
Loading...