58
NOTE: If vent does not work, check 10A fuse (photo H-2.1).
To avoid burning fuse, stop fan before reversing fan rotation (in/out).
When leaving trailer, always close roof vent cover (except for automatic or Maxxfan
models), or leave a two-inch gap with fan on “out”, to avoid most rain damage.
CLEANING INSTRUCTIONS:
• Turn OFF fan motor (on frame or on remote);
• Locate thumb tab on Pop ‘N Lock Screen, grab it and gently pull it down to unsnap, or turn
all 4 locks ½ turn if so equipped:
• Wash Pop ‘N Lock Screen and fan blade with a light non-abrasive soap, then rinse and dry.
• Re-install Pop ‘N Lock Screen by gently snapping it back in place or using all 4 locks.
Sliding Front Portable Table
ALTO R1713, R1723 and F1743: Front table slides and pivots to provide access to the front bench.
Table is also portable and can be used outside of its tracks and taken to rear of ALTO, or taken
outside. Table can also be taken apart and converted to a bed.
ALTO F2114 and F2414: Portable front table can be removed from track and converted to a
queen-size bed. There are two tracks, one inside at the front and one outside on the passenger
side. Leg can be folded to transport table or to install front bed.
NOTE: Do not lower table below horizontal while it is still attached to track as it would
damage or break the brackets. Always deploy leg and click it in place when you are setting
the table onto the track.
PHOTO K-13
Maxxfan
PHOTO K-14
To Next Page
Loading...