APPENDIX A: TECHNICAL SPECIFICATIONS
UNIFLOW
®
4 PULSED HEAT CONTROL
990-908 A-7
Front Panel Switches
User Interface Buttons .......................................................................................... 29 membrane keys
HEAT/NO HEAT Switch ............................................................................................... Heat only inhibit
RS-232/RS-485 Connectors
Connector type ................................................................................... standard 9 Pin D-sub connector
115VAC and 230VAC Input Power Settings
CAUTION
This section is for reference only. Input Voltage settings are performed at the factory
before the Control is shipped. While the voltage can be changed, doing so should only be
performed by a qualified MUC technician. These procedures require loosening of the
motherboard which will void the warranty and may cause permanent damage to the Control. If
you need to change the voltage setting, contact Amada Miyachi America using the phone, e-mail,
or mailing information on the CONTACT US page in the front of this manual.
NOTE: The 115/230VAC input power selection is made with jumper and switch settings on the Power
Circuit located on the left side of the Control.
To Next Page
Loading...