UNIFLOW
®
4 PULSED HEAT CONTROL
990-908 xv
CAUTION
Apply the specified source voltage.
Applying the wrong voltage can cause fire and electrical shock.
Keep water and water containers away from the Control.
Water spilled on the Control can cause a short circuit, electrical shock, or fire.
Use proper tools (wire strippers, pressure wire connectors, etc.) for terminations of the
connecting cables.
Do not nick the wire conductor. Doing so can cause a short circuit, electric shock, or fire.
Install the Control on a firm, level surface.
Injury may result if the Control falls over or drops from an uneven surface.
Keep combustible matter away from the Control.
Spatter can ignite combustible materials. If you cannot remove all combustible materials,
cover them with a non-combustible material.
Do NOT cover the Control with a blanket, cloth, etc.
Heat generated by the operating Control may ignite a blanket or cover.
Keep a fire extinguisher nearby.
Make sure there is a fire extinguisher in or near the shop in case of fire.
Regularly inspect and maintain the Control.
Regular inspection and maintenance is essential to safe operation and long life of the
equipment. If you see any damage, make necessary repairs before operation.
To Next Page
Loading...