How to unlock SYSTEM SECURITY on Amada Controller when ACCESS is DENIED?
If the Amada Controller displays 'ACCESS DENIED! SYSTEM SECURITY ON', access the SYSTEM SECURITY menu and re-enter your user password to unlock the System Security feature.
How to troubleshoot REFLOW ALARM on Amada Controller?
If you receive a REFLOW ALARM on the Amada Controller, try the following: 1. Set the Course Heating Rate one setting faster. 2. Increase the LOW LIMIT value. 3. Increase the Preheat Time. 4. Check cables between the Control output and the Reflow Soldering Head for loose connections. 5. Check connection between the thermode and thermode holder for loose connections. 6. Increase the diameter of the cables between the Control output and the Reflow Soldering Head.
What does OVER_PWR ALARM mean on Amada Controller and how to fix it?
If the Amada Controller displays an OVER_PWR ALARM, ensure that the thermocouple is plugged in, undamaged, and still bonded to the thermode. Also, check the thermocouple polarity. Then, recycle the power on the control.
How to fix OVER POWER ALARM on Amada Controller?
If the Amada Controller displays an OVER POWER ALARM, ensure that the thermocouple is plugged in, undamaged, and still bonded to the thermode. Also, verify the thermocouple polarity. Then, recycle the power on the control.
What to do if the 'EMERGENCY STOP ACTIVATED' message appears on my Amada Controller?
If the Amada Controller displays 'EMERGENCY STOP ACTIVATED', connect a normally closed relay or switch between pin 1 and pin 2 on the control rear panel connector, EMO. Note: Using a jumper wire in place of a relay or switch will work, but will not meet CE safety requirements. The operator must also clear the condition causing the emergency stop before reflowing can continue.
General| Brand | Amada |
|---|---|
| Model | UNIFLOW 4 REMOTE |
| Category | Controller |
| Language | English |
Identifies and explains the functions of the front panel controls and indicators.
Details key controls like Display, Keypad, and Switches.
Covers site preparation, space, and utility requirements for installation.
Explains how to connect external devices and components to the control unit.
Configuration of temperature and time limits, and envelope settings.
Adjusting heating rate and PID settings for optimal temperature control.
Accessing and configuring Hardware, Communications, Reflow, Security, and other settings.
Prerequisites, general safety, and preparation before operating the control.
Details graphical representation of temperature profiles and limits.
Explains the numerical display of process data and abbreviations.
How to use pre-defined profiles or manually input parameters.
Safety precautions and warnings before performing maintenance.
Diagnosing and resolving issues based on alarm messages.
Procedures for thermode cleaning, replacement, and contacting repair service.
Wiring for emergency stop and manual alarm reset functions.
To Next Page