Amazone AmaSpread 2 User Manual

TABLE OF CONTENTS
1 About this operating manual 1
1.1 Diagrams 1
1.1.1 Warnings and signal words 1
1.1.2 Further instructions 1
1.1.3 Instructions 2
1.1.4 Lists 3
1.1.5 Item numbers in figures 3
1.2 Other applicable documents 4
1.3 Your opinion is important 4
2
Safety and responsibility 5
2.1 Road traffic 5
2.2 Maintenance and storage 5
2.3 Design changes 6
2.4 Display 7
3
Intended use 8
4 Product description 9
4.1 Function of the control computer 9
4.2 Overview of the control computer 10
4.3 Menu selection 10
4.4 Buttons 13
4.4.1 Input keys and navigation keys 13
4.4.2 Function keys in the Work menu 13
4.5 Work display 14
5
Connecting the control computer 16
6
Basic operation 17
6.1 Switching the control computer
on and off 17
6.2 Navigating in the menu 17
6.3 Entering numerical values 18
6.4 Configuring the terminal 19
7
Adjusting the implement 20
7.1 Configuring the source for the
speed signal 20
7.1.1 Configuring the speed signal from
the tractor 20
7.1.2 Determining the pulses per 100 m 21
7.1.3 Entering the simulated speed 22
7.2 Configuring the low level
notification 23
7.3 Entering the rate increment for
changing the rate 23
7.4 Aligning the implement
horizontally 24
7.5 Select method for determining
the calibration factor 24
8 Managing products 25
8.1 Creating a new product 25
8.2 Selecting or deleting a product 26
8.3 Entering the product data 26
9
Filling the hopper 28
10 Determining the calibration
factor at a standstill 29
11 Working 31
11.1 Spreading fertiliser 31
11.2 Determining the calibration
factor manually while driving 32
11.3 Spreading on one side 33
11.4 Adjusting the spread rate 33
11.5 Switching part-width sections 34
11.6 Boundary spreading 35
TABLE OF CONTENTS
MG7387-EN-II | B.1 | 12.01.2022
I

Amazone AmaSpread 2 Specifications

General

Brand	Amazone
Model	AmaSpread 2
Category	Farm Equipment
Language	English