Amazone AmaSpread 2 - Determining the Calibration Factor Manually While Driving

6. When the switch-off point according to the
setting chart has been reached,
close the shutter.
7. When work is finished,
stop the spreading disc drive.
11.2 Determining the calibration factor manually while driving
1.
kg
Call up the "Scale" menu.
2. Start the manual calibration.
3.
Call up the "Work" menu.
4. Drive onto the field.
5. Run the spreading discs at the nominal speed.
CMS-I-00006214
6. When the switch-on point according to the
setting chart has been reached,
open the shutter.
The quantity spread during the calibration
procedure will be displayed.
7. When at least 250 kg of fertiliser has been
spread,
close the shutter.
8. Come to a stop and interrupt the spreading disc
drive.
ON
1.48
4794
kg
0
1/min
36 kg
CMS-I-00006215
9.
kg
Call up the "Scale" menu.
10. Stop the manual calibration.
CMS-I-00006217
CMS-T-00008977-B.1
11 | Working
Determining the calibration factor manually while driving
MG7387-EN-II | B.1 | 12.01.2022
32