Amazone Hektor - Calculation of the Required Minimum Ballasting at the Front G; Calculation of the Actual Front Axle Load of the Tractor T; Calculation of the Actual Total Weight of the Combined Tractor and Machine; Tat

Preparations on the tractor and plough
4.1.2 Calculation of the required minimum ballasting at the front G
V min
of the tractor
for assurance of the steering capability
b
a
bTbTc
F
G
L
VH
V
+
••+•−•
=
2,0
min
Enter the numeric value for the calculated minimum ballast G
V min
,
required on the front side of the tractor, in the table (Section 7.1.1.7).
4.1.3 Calculation of the actual front axle load of the tractor T
V tat
b
c
FbTbaG
T
HVV
tat
V
•−•++•
=
)(
Enter the numeric value for the calculated actual front axle load and
the approved tractor front axle load specified in the tractor operating
manual in the table (Section 7.1.1.7).
4.1.4 Calculation of the actual total weight of the combined tractor and machine
HLVtat
FTGG ++=
Enter the numeric value for the calculated actual total weight and the
approved total tractor weight specified in the tractor operating manual
in the table (Section 7.1.1.7).
4.1.5 Calculation of the actual rear axle load of the tractor T
H tat
tatV
tat
tatH
TGT
−=
Enter the numeric value for the calculated actual rear axle load and
the approved tractor rear axle load specified in the tractor operating
manual in the table (Section 7.1.1.7).
4.1.6 Tyre load capacity
Enter the double value (two tyres) of the approved load capacity (see,
for example, tyre manufacturer's documentation) in the table (Section
7.1.1.7).
26
Hektor BAG0186.1 07.19