Amazone Hektor - Checking the Condition of the Shares and Wear Parts; Checking the Shear Bolts

Cleaning, maintenance and repair
Regulating the oil pressure for the stone release
1. Connect the long end of the pressure
control hose to the hydraulic cylinder.
2. Connect the short end to the pressure
gauge on the tractor hydraulic system.
3. Read the pressure on the pressure gauge
and set the desired tripping pressure.
4. Close the stop tap on the plough.
5. Depressurise the hose using the tractor
hydraulic system.
6. Disconnect the hose.
Pressure on the hydraulic accumulator:
The gas pressure side may only be set by the
dealer and must be checked once annually!
Pre
-tensioning
pre
ssure
(nitrogen)
90 bar
Min. working
pre
ssure
(hydr. oil)
90 bar
The maximum pressure set must
not exceed 140 bar, otherwise
co
mponent parts on the plough will
be subject to overload and damage.
Max. working
pre
ssure
(hydr. oil)
14
0 bar
10.5 Checking the condition of the shares and wear parts
Replace worn shares and mould boards promptly
to prevent damage to the frogs or supporting
parts. The same applies to leading tools, if
equipped
10.6 Checking the shear bolts
Check the bolts for tightness.
Required tightening torque for the bolts:
56
Hektor BAG0186.1 07.19