Coupling and uncoupling the implement
5 Coupling and uncoupling the implement
• When mounting or dismounting the plough on the tractor and
when operating the lifting gear, ensure that there is nobody
standing between plough and tractor
• There must be nobody standing between the tractor and
implement unless the tractor is secured by the parking brake
and/or wheel chocks to prevent it from rolling away. Switch off
engine, remove ignition key.
• There is a risk of tipping when the plough is being dismounted. It
is therefore essential that the implement be secured with stand
supports.
• The plough must only be mounted and dismounted on firm, level
ground
5.1 Uncoupling the implement
1. Couple the lower link and slightly lift the 3-
point frame.
2. Release the chain from the 3-point frame
3. Lower the 3-point frame until the top link is
flush with the upper coupling point.
4. Couple and lock the top link.
5. Adjust the length of the top link so that the
axle (1) is positioned vertically.
6. Couple the supply lines.
7. Raise both jacks and lock them.
8. Raise the implement using the running
gear.
30
Hektor BAG0186.1 07.19
To Next Page
Loading...
