Amazone Hektor - Cleaning

Cleaning, maintenance and repair
10.2 Cleaning
• The implement must not be cleaned with a steam jet cleaner
within the first 6 weeks! After this time, only clean at a nozzle
distance of at least 50 cm at max. 100 bar and 50°C!
• When the cleaning and care instructions are not observed, any
resulting paint damage will not be covered by the warranty!
• Pay particular attention to the brake, air and hydraulic hose lines.
• Never treat brake, air and hydraulic hoses with petrol, benzene,
petroleum or mineral oils.
• After cleaning, grease the implement, in particular after cleaning
with a high pressure cleaner/steam jet or liposoluble agents.
• Observe the legal regulations for handing and disposing of
cleaning agents.
Cleaning with a high pressure cleaner/steam jet
• Always observe the following points when using a pressure
washer/steam jet for cleaning:
ο Do not clean any electrical components.
ο Do not clean any chromed components.
ο Never aim the cleaning jet of the cleaning nozzle of the
high pressure cleaner/steam jet directly at lubrication
points, bearings, rating plates, warning signs, and stickers.
ο Always maintain a minimum nozzle distance of
300 mm between the high pressure or steam jet cleaning
nozzle and the implement.
ο The set pressure of the high-pressure cleaner/steam jet
must not exceed 80 bar.
ο Permissible water temperature max. 50°C.
ο Do not clean the implement with warm water at ambient
temperatures below 10°C.
ο The nozzle spraying angle must be at least 25°.
ο Do not use a spraying jet booster.
ο Comply with safety regulations when working with pressure
washers.
52
Hektor BAG0186.1 07.19