• Observe the permitted axle and drawbar loads as well as the
total weights!
• When driving in curves, take account of the wide sweep and the
centrifugal mass as well as the high centre of gravity of the
implement!
• Never leave the driver's platform while the tractor is in motion!
• Riding on the implement during work or road transport is not
permitted.
• The road traffic regulations must be observed at all times when
using public roads!
1. Lift the implement completely using the running gear and then
lower again a bit. Pay attention to sufficient ground clearance.
→ This activates the shock absorber.
2. Close the stop taps.
(1) Running gear hydraulic system
(2) Hydraulic front furrow adjustment
(3) Hydraulic turnover system
Raise the implement to mid-height using the running gear.
36
Hektor BAG0186.1 07.19
To Next Page
Loading...
