EasyManua.ls Logo

AMERITEC AM-48 - Page 7

AMERITEC AM-48
179 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table of Contents (18-0015) AM-48 Test Set
0015-TOC
vi
8.5 Notched Noise (Noise with Tone) ..................................................... 8-4
8.6 Signal-to-Noise (S/N) Ratio...............................................................8-5
8.7 P/AR Measurements.......................................................................... 8-6
8.8 Gain Slope ......................................................................................... 8-8
8.9 Idle Channel Impulse Noise .............................................................. 8-9
8.10 Phase Jitter.................................................................................... 8-11
8.11 Amplitude Jitter..............................................................................8-11
8.12 Notched Impulse Noise .................................................................8-12
8.13 Phase Hits......................................................................................8-12
8.14 Gain Hits ........................................................................................8-12
8.15 Dropouts......................................................................................... 8-12
9. CIRCUIT DIAGRAMS............................................................................... 9-1
9.1 Introduction ........................................................................................ 9-1
9.2 AM-48 Simplified Block Diagram.......................................................9-1
9.3 Impedance Adapter Schematic......................................................... 9-3
10. WARRANTY, SERVICE, AND CALIBRATION .................................. 10-1
10.1 Warranty......................................................................................... 10-1
10.2 Service Policy ................................................................................10-1
10.3 Calibration Policy........................................................................... 10-1
10.4 Return of Unit.................................................................................10-2
11. GLOSSARY...........................................................................................11-1

Table of Contents