AM-48 Test Set (18-0015) Operating Instructions
0015-S07
7-1
7. OPERATING INSTRUCTIONS
Note: Set up the AM-48 per Section 6 before performing
operations in this section.
7.1 Introduction
The AM-48 operating instructions in this section are divided into five
(5) major subjects and associated paragraphs as listed below:
7.2 General Instructions and Notes
7.3 General Operating Notes
7.4 Figure Format
7.5 General Switch Setup
7.6 Multiple Use of Keys
7.7 Memory
7.8 General Procedure to Set New Parameter Values
7.9 Send (Generator) Modes and Parameter Settings
7.10 Type of Send Signals
7.11 Send Quiet
7.12 Set Parameters from Quiet Display
7.13 Send Momentary Variable Tones
7.14 Send 1004 Hz
7.15 Send Continuous Variable Tone
7.16 Send 3-Tone Slope
7.17 Send Variable Sweep
7.18 Send PAR Waveform
7.19 Send Momentary 2713 Hz Tone
7.20 General Measure Mode Notes
7.21 Accuracy of Measurements
7.22 Absolute and Relative Measurements
7.23 Special Measurement Requirements
7.24 Timed Tests
To Next Page
Loading...