Operating Instructions (18-0015) AM-48 Test Set
0015-S077-2
7.25 Measure Modes and Parameter Settings
7.26 Measure Level and Frequency
7.27 Measure Noise
7.28 Measure PAR
7.29 Measure Impulse Noise
7.30 Measure Notched Noise
7.31 Measure S.N Ratio
7.32 Measure Phase Jitter
7.33 Measure Amplitude Jitter
7.34 Measure Transients (Impulse Noise, Notched Noise,
Phase Hits, Gain Hits, and Dropouts)
7.35 Miscellaneous Operations
7.36 Store and Recall
7.37 Dialing
7.38 Talking
7.39 Printing
7.40 Auto Study Result Save
7.41 Impedance Adapter Measurement Corrections
7.42 Auto Calibrate
It is assumed in this section that the user is familiar with basic
AM-48 operation, having followed the self-test instructions of
Section 5. Instead of step-by-step procedures with full details, the
instructions refer to the figures, which summarize the information
needed to perform a test.
Read the general notes in ¶7.2 thru 7.10 and 7.20 thru 7.24 before
going to specific operating instructions.
To Next Page
Loading...