Table of Contents (18-0015) AM-48 Test Set
0015-TOC
viii
Figure 7-3. Parameter Settings from 3-TONE Slope and
PAR SEND Displays.........................................................7-20
Figure 7-4. Parameter Settings from SWEEP SEND Display...................7-21
Figure 7-5. L/F, NOISE, and PAR MEASURE Displays............................ 7-28
Figure 7-6. IMPLS MEASURE Displays.....................................................7-32
Figure 7-7. Notched NOISE and S/N Ratio MEASURE Displays ............. 7-33
Figure 7-8. Phase JTR and Amplitude JTR MEASURE Displays............. 7-35
Figure 7-9. TRANS MEASURE Displays..........................................7-39, 7-40
Figure 7-10. Recall and Store Operations ................................................. 7-42
Figure 7-11. SEND Printouts...................................................................... 7-52
Figure 7-12. MEASURE Printouts, Absolute Measure Mode....................7-54
Figure 7-13. MEASURE Printouts, Relative Measure Mode.....................7-55
Figure 7-14. Impedance Adapter Correction Value Memory Aid............... 7-58
Figure 7-15. AM-48 Auto Calibrate Prompts..............................................7-60
Figure 8-1. Level and Noise Units of Measurement....................................8-2
Figure 8-2. Impulse Noise Thresholds and Blanking Intervals.................. 8-10
Figure 9-1. Simplified Block Diagram of the AM-48.....................................9-2
Figure 9-2. Schematic Diagram of the Impedance Adapter........................ 9-4
To Next Page
Loading...