Dansensor® CheckMate 3 EN User Guide 17
P/N 300042-I
05/2019
Logging off
To log off press the key from the measuring screen.
When device is switched into Standby or Sleep mode either automatically or when manually
selected from the “Main menu”, current user will be logged off.
Daily Start-Up
At the start of the working day the device will normally be in one of the following modes:
•Switched Off
•Standby mode
•Sleep mode
Starting the device from the either of the three modes is described in the following:
1. If device is switched off apply power to it.
If device is in either Standby or Sleep mode simply touch the screen.
2. If no login is required the device will start up and automatically run a self-test and warm-
up period of approx. 10 min.
If device is started from Standby mode the sensor temperature has been maintained and the device
will be ready after max. 1 min.
3. If User login or login with User ID is required, login as described in "Login" on page 16.
4. After a successful login the device runs the self-test and warm-up period and when
finished the display changes to show the measuring screen.
5. Now the device is ready to begin measuring.
Heating
Time left XX min
Product: 47
Meat 400 gr.
Measuring mode: Manual spot
Product Menu
08/17/06 13:46
Product: 47
Meat 400 gr.
Measuring mode: Manual spot
Product Menu
08/17/06 13:46
%
O
2
Bal
%
CO
2
Press to measure
0,482 29,5
70,0
To Next Page
Loading...
Need help?
General
