Ametek mocon Dansensor CheckMate3 User Manual

Dansensor® CheckMate 3 EN User Guide 53
P/N 300042-I
05/2019
Zirconia O
2
sensor
Measure time Min. 3 sec. (incl. 1 sec. measure delay time)
1
Sample volume Min. 1,35 ml (with a 3 sec measuring time and a flow of
27 ml/min)
Typical sample volume 2,83 ml ( with a 5 sec measuring time and a flow of
34 ml/min)
Reference gas Ambient atmospheric air (20.9 % O
2
)
Service calibration interval 12 months
1
This time should be increased when the sample pressure is lower than atmospheric pressure.
Electrochemical O
2
sensor
Measure time Min. 7 sec. (incl. 1 sec. measure delay time)
1
Sample volume Min. 3,15 ml (with a 7 sec. measuring time and a flow
of 27 ml/min)
Typical sample volume 3,97 ml (with a 7 sec. measuring time and a flow of
34 ml/min)
2
Response time (T
95
) 9 seconds
Service calibration interval 6 months
1
This time should be increased when the sample pressure is lower than atmospheric pressure.
2
The sample time (and volume) can be increased by the DST function .
See
"Dynamic Sample Time (DST)" on page 18.
CO
2
sensor
Measure time Min. 10 sec. (including 1 sec measure delay time)
1
Sample volume Min. 4,5 ml (with a 10 sec measuring time and a flow of
27 ml/min)
Typical sample volume 8,5 ml (with a 15 sec measuring time and a flow of
34 ml/min)
Service calibration interval 12 months
1
This time should be increased when the sample pressure is lower than atmospheric pressure.

Ametek mocon Dansensor CheckMate3 Specifications

General

Brand	Ametek
Model	mocon Dansensor CheckMate3
Category	Laboratory Equipment
Language	English