Ametek mocon Dansensor CheckMate3 User Manual

Dansensor® CheckMate 3 EN User Guide 31
P/N 300042-I
05/2019
3. Menus and Settings
General
When device is switched on (after power off) it is locked in User access level. In User access
level the operator has access to a limited number of functions only and is not allowed to
perform parameter set-up.
To obtain full access you have to change the device to Supervisor access level.
See "Access level" on page 45 for details.
Main menu
Pressing the key from the measuring screen brings up the Main menu
From the Main menu you can select the following submenus:
Menu items marked with an asterisk (*) are not available in User access level.
Product menu* Create, edit and delete products.
Display and delete logged product data.
See "Product menu" on page 33 for details.
 Data log View logged data for currently selected product.
See "Data log" on page 36 for details.
 Diagnostic menu Display device’s internal parameters and error diagnostics.
See "Diagnostic menu" on page 36 for details.
 General setup* Setting of various device parameters.
See "General setup" on page 37 for details.
 Access level Selection of access level for User, Supervisor and Service.
See"Access level" on page 45 for details.
 Calibration* Calibration of sensors - for Service Technicians only.
Product: 47
Meat 400 gr.
Measuring mode: Manual spot
Product Menu
08/17/06 13:46
%
O
2
Bal
%
CO
2
Press to measure
0,482 29,5
70,0
13:46
08/17/06
Main menu
Data log
Product menu
Diagnostic menu
General setup
Calibration
Export / Import
Standby
Sleep
Language
Access level

Ametek mocon Dansensor CheckMate3 Specifications

General

Brand	Ametek
Model	mocon Dansensor CheckMate3
Category	Laboratory Equipment
Language	English