Dansensor® CheckMate 3 EN User Guide 25
P/N 300042-I
05/2019
Performing a measurement
1. Make sure that the device is in Ready mode - see "Modes" on page 15.
2. Select appropriate product - see "Selecting a product for measuring" on page 23.
3. Place a septum
on the product/package to be measured/analysed. This ensures
leak-free gas extraction and thus accurate measuring.
4. Penetrate the septum
with the needle so that the gas can be sucked in from the
package through the tip.
CAUTION! Do not let the needle tou17ch the product, fluid or anything else in
the package, as this could soil the needle, hose or filter.
If this happens, the needle, hose and filter must be replaced to avoid destroying
sensors or other items inside the unit.
5. The measuring method is displayed at the top of the screen
.
6. If selected product requires keying in of data before measurement (see "Edit product" on
page 33 for details) Data required. Press will be displayed in the bottom of the
measuring screen
.
7. Pressing the key will bring up the appropriate touch screen keyboard for keying in of
the required data. Key in the data and confirm by pressing the OK key, which will either
bring up the next data request screen if required or return to the measurement screen
ready for measuring.
8. Now start the measurement as required - see "Measuring modes" on page 22 for details.
4
5
To Next Page
Loading...
